T. Shimazaki, S. Akamaru, T. Abe, M. Kubo
M. Danno, K. Matsubara, M. Inoue, T. Abe
K. Matsubara, M. Danno, M. Inoue, T. Abe
M. Hara, S. Ogino, K. Nishimura, M. Matsuyama
S. Akamaru, M. Hara, K. Kato, T. Noguchi, K. Nakamura, Y.Hatano, M.Matsuyama
K. Isobe, V. Kh Alimov, T. Yamanishi, Y. Torikai
S. Abe. M. Matsuyama
S. Akamaru, K. Okazaki, M. Hara, M. Matsuyama
Annual Report31-1
Review
T. Shimazakia) S. Akamarub) T. Abeb), M. Kuboa)
a)Fracture and Reliability Research Institute, Graduate School of Engineering, Tohoku University
6-6-11 Aoba, Aramaki, Aoba-ku, Sendai 980-8579
b)Hydrogen Isotope Research Center, University of Toyama
3190 Gofuku, Toyama 930-8555
The Ru/TiO2 catalyst holds great promise as a key material for artificial conversion of CO2 to CH4 through several hydrogenation elementary reactions. In this study, we examined the bent structure of CO2 molecules on the Ru(0001) surface and Ru-nano-clusters to investigate the Ru/TiO2 catalytic reaction, based on the density functional theory (DFT) at the generalized gradient approximation (GGA) level under the periodic boundary condition. The bent structure of CO2 can trigger a series of hydrogenation reactions leading to the formation of CH4, and this structure can be observed not only on the Ru (0001) surface and the Ru nano-particles on the TiO2(101) surface but also on the homogeneous Ru complex catalyst. These findings suggest that the bending of the CO2 molecule on Ru metal is a key process to activate the stable CO2 molecule.
Annual Report31-2
Original
M. Danno, K. Matsubara, M. Inoue, T. Abe
Hydrogen Isotope Research Center, University of Toyama, Gofuku 3190, Toyama 930-8555, Japan
Abstract
A Pd/ZnO sample prepared by the polygonal barrel-sputtering method was tested for the performance in methanol steam reforming in comparison with a similar sample from a conventional wet process. Transmission electron microscopy (TEM) showed that sputtering produced smaller and more uniformly sized Pd nano-particles than the wet process. Steam reforming of methanol was conducted by supplying a gaseous mixture of methanol + H2O + Ar. In the experiment with the polygonal barrel-sputtering method, H2 generation started at a lower temperature (80℃) than that for the wet process (100℃). In addition, H2O was scarcely consumed at both of the samples when H2 was generated at < 100 ℃. These results suggested that the sputtering preparation allowed direct decomposition of methanol to occur easily at less than 100℃, as supported by the observed relationship between the CO/CO2 generation ratio and the reaction temperature. It should be noted that the smaller Pd particle sizes for the sputtering method were maintained at reaction temperatures up to 150 ℃.
Annual Report31-3
Original
K. Matsubara, M. Danno, M. Inoue, T. Abe
Hydrogen Isotope Research Center, University of Toyama, Gofuku 3190, Toyama 930-8555, Japan
Abstract
We demonstrated surface nitridation of titanium particles using the polygonal barrel-plasma treatment system. In order to verify the formation of TiN, a Ti plate was treated in our plasma treatment system. The color of the Ti plate changed from metallic to gold as a result of N2 plasma treatment. Glow discharge optical emission spectrometry of the plasma-treated Ti plate confirmed that nitrogen was inserted. From XPS measurements, it was also found that the nitrogen in the sample was ascribed to the formation of Ti-N bonds. It should be noted that the X-ray diffraction patterns of the Ti plate before and after the plasma treatment showed only the reflection peaks of Ti metal, supporting that the Ti-N bond formation occurred only on the surface of the plate. Subsequently, N2 plasma treatment was applied to Ti particles. The plasma treatment using a swinging motion of the barrel containing Ti particles changed the color of the particles uniformly from gray to brown. The UV-VIS absorbance spectrum of the plasma-treated Ti particles was similar to that of the plasma-treated Ti plate. This result was considered a proof of the Ti-N bond formation on Ti particles achieved by the polygonal-barrel plasma treatment system.
Annual Report31-4
Original
M. Hara1), S. Ogino1), K. Nishimura2), M. Matsuyama1)
1)Hydrogen Isotope Research Center, University of Toyama, Gofuku 3190, Toyama 930-8555, Japan
2)Faculty of Engineering, University of Toyama
Gofuku 3190, Toyama 930-8555, JAPAN
Abstract
To obtain the isotherms of Zr(Mn1-xCrx)2 - H system, the activation process was studied. The Zr(Mn0.5 Cr0.5 )2 sample prepared was heated at 873 K for 2 hrs in vacuum as the activation process for isotherm measurements. The isotherm at ambient temperature had a single plateau. However, the width of the plateau region decreased in the course of repetitive isotherm measurements, and the plateau disappeared by the 5th measurement. The disappearance of the plateau region would be explained by the surface poisoning due to the chromium oxide yielded by the activation process.
Annual Report31-5
OriginalY. Hatano1, A. Livshits2,
A. Busnyuk2, V. Alimov2, M. Matsuyama1
1Hydrogen Isotope Research Center, University of Toyama,
Toyama 930-8555, Japan
2Bonch-Bruyevich University,
61 Moika, St. Petersburg 191186, Russia
Abstract
The sticking probability of H% on the surface of polycrystalline V covered with oxygen was examined as a function of oxygen concentration in the bulk metal (0.4 to 3.3 at.%) at specimen temperatures from 200 to 1000℃. At all temperatures examined, the sticking probability was strongly dependent on the oxygen concentration in the bulk. Such correlation between the reaction rate of H2 on the surface and the oxygen concentration in the bulk was attributed to the dependence of concentration of oxygen vacancies (holes in surface oxygen coverage) on the oxygen bulk concentration. The values of sticking probability were relatively high even at the oxygen bulk concentration of 3.3 at.% the oxygen coverage on vanadium was rather "holey" even at the oxygen concentration close to the solubility limit. The activation energy for H2 dissociation on such holes in the coverage was evaluated to be 10 kJ/mol H2.
Annual Report31-6
Original
K.Isobe, T.Yamanishi
Tritium Technology group, Japan Atomic Energy Agency, Tokai, Ibaraki, 319-1195, Japan
Abstract
The limits on tritium inventory in the vacuum vessel and the need for prevention of impurity ingress into plasma make plasma-surface interaction on tungsten an important issue. It is well known that plasma exposure on tungsten makes some kinds of blisters on the surface and increases the hydrogen inventory. On the other hands, there is a possibility that plasma exposure would change the characteristic of surface and surface region in tungsten and cause the increase of tritium inventory. To understand the change of tritium inventory in the surface region and surface in tungsten by plasma exposure, tritium concentration in tungsten exposure by low-energy (38eV), high-flux D plasma with was examined with BIXS after thermal exposure of tritium gas. D plasma exposure was carried out at specimen temperature around 495 and 550K. After that, specimens were exposed to gaseous tritium diluted with deuterium at 473K for 3 hours. The tritium concentration was measured with BIXS. The tritium concentration in surface and surface region was found to be increased by plasma exposure. And its concentration of tungsten exposed at 495 K was estimated to be twice higher than that of as-received tungsten.
Annual Report31-7
Technical Report
S. Abe. M. Matsuyama
Hydrogen Isotope Research Center,
University of Toyama, Gofuku 3190, Toyama 930-8555, Japan
Abstract
A tantalum wire was contaminated with tritium unexpectedly generated during a tritium exposure experiment on ceramic materials. The amount of tritium retention in the tantalum wire was estimated to be 13.3 GBq, and 88% of this amount was recovered as tritium gas by heating at 943 K. After additional evacuation at the same temperature, a part of the wire was dissolved in an aqueous solution of hydrofluoric acid. The result showed that heating was able to decrease the residual amount of tritium in the tantalum wire finally to 564 kBq. Subsequently, a part of the tantalum wire was immersed in pure water for about one month to examine the effect of water decontamination. This removed 37% of the residual tritium in the tantalum wire. Altogether the contamination level decreased to 355 kBq, which was 2.7×10-3% of the initial tritium amount in the wire.
Annual Report31-8
Note
S. Akamaru, K. Okazaki, M. Hara, M. Matsuyama
Hydrogen Isotope Research Center, University of Toyama, Gofuku 3190, Toyama 930-8555, Japan
Abstract
An alternating-current magnetometer was assembled to measure the magnetic susceptibility of metal hydride in hydrogen atmosphere, and its performance tests were carried out. The magnetometer was designed to be integrated into the conventional pressure-composition-temperature (PCT) measurement system without any reconstruction. Calibration of the magnetometer was performed using a paramagnetic Gd2O3 powder, and it gave a linear relationship between the output signal and the magnetic moment of Gd2O3 powder. The magnetic susceptibility of PdHx (0 ≦ × ≦ 0.7) was measured simultaneously with the PCT curve. The magnetic susceptibility of Pd hydride decreased with increasing hydrogen concentration in Pd and finally reached zero at the hydrogen concentration above 0.65. The behavior of magnetic susceptibility and PCT curves quantitatively agreed with the previously reported values.